Table of Contents
Advertisement
5.5.7
To remove and replace the Keyscan Board, perform the following procedure:
1.
2.
3.
4.
Keyscan Board
Figure 5-10 Keyscan Board, Removal/Replacement
5-16 Field Service
Removing/Replacing the Keyscan
Board
Open up the base assembly as described in the previous paragraph.
Gently lift the floppy drive cable up and backwards to gain access to
the Keyscan Board.
Using a straight slot screwdriver, gently pry the Keyscan Board upwards
(held in place by its bottom connector). Remove the board from the
notebook (see Figure 5-10).
Replacement is essentially the reverse of Steps 1 through 3 above.
Main Board Connector
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
