Reading Ctcss/Dpl Values - Motorola RDU2020 - RDX UHF - Radio Owner's Manual

value. If you short press the PTT button again,
the radio will signal you the second digit value.
PTT
Mode
Figure 2:

Reading CTCSS/DPL Values

If you continue short pressing the PTT button
as shown in Figure 1: Entering Programming
Mode on page 37 (stage 2), the radio will move
forward to programming CTCSS/PL Codes.
When reading the values for CTCSS/PL Codes
the radio signals you the digit codes each time
you short press the PTT button.
40
English
PROGRAMMING M
1
Frequencies
PTT
PTT
First
Second
Digit Digit
Long
Long
PTT
PTT
Idle
Programming
Reading Frequencies Values
You will have to read three digits as RDX
Series™ have up to 122 codes available (refer
to "Frequencies and Codes Charts" Section).
The following is an example of the order in
2
which your radio will be signaling the '118'
CTCSS
CTCSS/DPL code:
First
Digit
PTT
Figure 3:
• Short press the PTT button. The radio will signal
you the first digit '1'.
• Short press PTT button again and the radio will
show the second digit '1' and,
• Finally, short press PTT again and radio will show
the third digit '8'.
Example of How to Program Values