Table of Contents
Advertisement
CHANGE TO BUFFING/POLISHING BONNET
See Figure 7.
Remove the application bonnet by loosening the drawstring
and slipping the bonnet off the pad. Replace with buffing/
polishing bonnet, attaching it the same way as the applica-
tion bonnet.
Buff the surface in the same order as it was polished, starting
with large flat surfaces and ending with hard-to reach areas.
Use the same motion as for polishing, a broad sweeping criss-
cross pattern on large flat areas and small circular motions
on all other areas. Remember to let the tool do the work.
NOTE: The part number for one replacement applicator bon-
net and one replacement buffing bonnet is A38RB01.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Electric tools used on fiberglass material, wallboard, spack-
ling compounds, or plaster are subject to accelerated wear
and possible premature failure because the fiberglass chips
and grindings are highly abrasive to bearings, brushes,
OPERATION
MAINTENANCE
commutators, etc. Consequently, we do not recommended
using this tool for extended work on these types of materi-
als. However, if you do work with any of these materials, it
is extremely important to clean the tool using compressed
air.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required.
APPLICATION AND BUFFING/POLISHING
BONNETS
Both the application and buffing/polishing bonnets are reus-
able. For maximum life and performance, hand wash after
use and allow them to air dry. If needed, the bonnets can
be machine washed in cold water with a small amount of
detergent, then machine dried using low heat.
FOAM PAD
It is important that the pad retain its original shape and dimen-
sions. Allow it to dry completely after each use. Make sure
to remove the bonnets, wash them, and store separately.
Polisher should be stored with the pad facing up in order to
extend pad life and retain its shape. Be careful not to use
too much polish at one time. If the pad becomes saturated,
it will not last as long.
12
Fig. 7
Advertisement
Table of Contents
