Table of Contents
Advertisement
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
3.
SAS LSI1068 ports LED connector (18-1 pin SASLED1)
( For KFN4-D16/SAS model only )
This connector is for SAS link state's LED. The active LOW Fault LED
signals are nominally configured to indicate a SAS link fault for each
respective phy. The active LOW Activity LED signals are nominally
configured to indicate SAS link activity.
KFN4-D16 (Series) SASLED connector
2-28
Drive jumper
setting
Cable-Select or
Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
Mode Cable of
device(s)
-
Master
Slave
Master
Slave
SASLED1
1
Chapter 2: Hardware information
Cable connector
Black
Black
Gray
Black or gray
Advertisement
Table of Contents
