Internal Connectors; Floppy Disk Drive Connector (34-1 Pin Floppy); Ide Connectors (40-1 Pin Pri_Ide1, Sec_Ide) - Asus KFN4-D16 1U User Manual

2.7.2

Internal connectors

1. Floppy disk drive connector (34-1 pin FLOPPY1)
This connector is for the provided floppy disk drive (FDD) signal cable.
Insert one end of the cable to this connector, then connect the other
end to the signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection
when using a FDD cable with a covered Pin 5.
KFN4-D16 (Series) Floppy Disk Drive Connector
2. IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)
The onboard IDE connector is for Ultra DMA 133/100/66 signal
cable. There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to
the motherboard's IDE connector, then select one of the following
modes to configure your device(s).
KFN4-D16 (Series) IDE connectors
ASUS KFN4-D16 Series
FLOPPY
PIN 1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
2-27