Asus DSEB-DG SAS User Manual page 157

The Create New Array screen shows the disks you can add to make up the
3.
IME volume.
Integrated Mirroring Enhanced (IME) supports three to eight disks, or seven
mirrored disks plus a hot spare disk. Use the arrow key to select a disk, then
move the cursor to the RAID Disk column. To include this disk in the array,
press <+>, <->, or <Space>.
You may also specify the Hot Spare disk here. Select the disk, then move the
cursor to the Hot Spr column, then press <+>, <->, or <Space>.
LSI Logic Config Utility
Create New Array -- SAS1068
Array Type:
Array Size(MB):
Slot Device Identifier
Num
0 SEAGATE ST373454SS
1 SEAGATE ST373454SS
2 SEAGATE ST373454SS
3 SEAGATE ST373454SS
Esc = Exit Menu
SPACE/+/- = Select disk for array or hot spare
By default, the RAID Disk field shows No before array creation. This field is
grayed out under the following conditions:
• The disk does not meet the minimum requirements for use in a RAID array.
• The disk is not large enough to mirror existing data on the primary drive.
• The disk has been selected as the Hot Spare for the RAID array.
• The disk is already part of another array.
4. Repeat step 5 to add the other disks to the volume.
5. When done, press <C> to create the array, then select Save changes then
exit this menu.
Create and save new array?
Cancel Exit
Save changes then exit this menu
Discard changes then exit this menu
Exit the Configuration Utility and Reboot
6. The utility creates the array.
LSI Logic Config Utility
Processing...may take up 1 minute
Creating RAID array
ASUS DSEB-DG Series
v6.16.00.00 (2007.05.07)
IME
51498
RAID
Disk
0003 [Yes] [NO]
0003 [NO]
0003 [Yes]
0003 [Yes]
F1/Shift+1 = Help
Hot Drive Pred
Spr Status Fail
------- ----
[NO] ------- ----
[NO] ------- ----
[NO] ------- ----
C = Create array
v6.16.00.00 (2007.05.07)
Size
(MB)
70007
70007
35003
35003
5-51