Table of Contents
Advertisement
4049-XXX
A [Passed] message indicates the printer connection to the printer
cable connector is good.
A [Failed] message indicates a defective RIP board.
Note: Ignore the number displayed after a failure is displayed.
10. Press Return to return to the Diagnostics mode main menu.
11. Turn the printer off, and remove the wrap plug from the interface
connector.
Other Tests
Developed Image Test
Use the Developed Image Test to isolate print quality problems. You
might have to practice this procedure several times to get the timing
correct.
To run the Developed Image Test:
1. Open the front exit tray.
2. Print the test page.
3. As soon as the leading edge of the paper is visible coming out
the front exit slot, turn off the printer.
4. Remove the print cartridge and look at the image on the photo-
conductor.
LAN Information
The printer may be connected to one of the following LAN types:
Token-Ring
Ethernet 10BASE-T
Ethernet 10BASE2
LocalTalk
The printer test page indicates to which type of LAN the printer is
connected.The Network external connectors are shown below.
3-17
Advertisement
Table of Contents
