Table of Contents
Advertisement
4049-XXX
High Capacity Feeder Cover
1. Remove all paper from the feeder.
2. Turn the printer power off and remove the line cord from the
electrical outlet and the feeder power jumper cable from the
printer.
3. Remove all paper trays and auxiliary rear feeders from the
printer.
4. Remove the printer from the feeder.
5. Remove the four screws in the top of the feeder.
6. Carefully place the feeder on its left side and remove the eight
screws holding the cover to the bottom plate. The feeder mech-
anism is attached to the bottom plate.
7. Slide the feeder and bottom plate partially out of the cover. Dis-
connect the power supply cable and the door switch cable from
the circuit board before removing the feeder from the cover.
4-47
Advertisement
Table of Contents
