Table of Contents
Advertisement
Gigabit Ethernet Switch User's Guide
To use the trap manager function featured on this Switch, enter the desired community string and IP address
of the trap receiving station (up to four are allowed). A trap receiving station is a device that constantly runs a
network management application to receive and store traps. Click Apply to put the settings into effect
The information is described as follows:
IP Address The IP address of the trap receiving station.
Community A user-defined community name.
SNMP Manager
To use the functions on this window, enter the desired community string for SNMP management on the
Switch in the Community String field and the desired Access Right setting in the next field. You may enter up
to four IP addresses of trap receiving stations in the Trap Manager window of the Configuration section.
Then click Apply to put the settings into effect.
The information is described as follows:
Community String A user-defined SNMP community name.
Access Right The permitted access of Read Only or Read/Write using the SNMP community name.
Figure 7-7. SNMP Manager window
78
Advertisement
Table of Contents
