Connecting The Switch; Pc To Switch; Switch ( Other Devices ) - D-Link DGS-3208TG - Switch User Manual

Gigabit Ethernet Switch User's Guide
4
4 C T S
ONNECTING HE WITCH
This chapter describes how to connect the DGS-3208TG to your Gigabit Ethernet network.

PC to Switch

A PC can be connected to the Switch via a four-pair Category 5 cable or a fiber optic cable. The PC should be
connected to any of the eight ports of the DGS-3208TG.
Figure 4-1. DGS-3208TG Switch connected to a PC or Workstation (full-duplex mode is required)
The LED indicators for PC connection are dependent on the LAN card capabilities. If LED indicators are not
illuminated after making a proper connection, check the PC's LAN card, the cable, Switch conditions, and
connections.
The following are LED indicator possibilities for a PC to Switch connection:
The Link/ACT LED indicator lights up upon hookup.
Switch to Switch (other devices)
The Switch can be connected to another switch or other devices (routers, bridges, etc.) via a fiber optic cable.
10