D-Link DGS-3024 - Switch Manual page 39

This indicates if a Telnet connection is currently enabled on the Switch. The default is Enabled.
Telnet Status
Telnet TCP Port The TCP port number. TCP ports are numbered between 1 and 65535. The "well-known" TCP
port for the Telnet protocol is 23.
Number (1-65535)
Web Status Web-based management is Enabled by default. If Disabled is chosen, the ability to configure
the system through the web interface as soon as these settings are applied will be lost.
Web TCP Port The TCP port number currently being utilized by the Switch to connect to the web interface. The
"well-known" TCP port for the Web interface is 80.
Number (1-65535)
RMON Status This indicates if RMON is enabled on the Switch. The default is Disabled.
GVRP This indicates if Group VLAN Registration Protocol (GVRP) is enabled on the Switch. GVRP is
a protocol that allows members to dynamically join VLANs. The Switch's GVRP settings can be
changed on the GVRP Settings window (Configuration → VLANs → 802.1Q Port Settings).
The default is Disabled.
The algorithm that the Switch uses to balance the load across the ports that make up the port
Link Aggregation
trunk group is defined by this definition. Choose MAC Source, MAC Destination, or MAC Src &
Algorithm
Dest, (For further information, see the Link Aggregation section, under the Link Aggregation
folder).
Switch 802.1x
The Switch's 802.1x function may be enabled by port; the default is Disabled. This field must be
enabled to view and configure certain windows for 802.1x. More information regarding 802.1x,
its functions and implementation can be found later in this section, under the Port Access
Entity folder. Port-Based 802.1x specifies that ports configured for 802.1x are initialized based
on the port number only and are subject to any authorization parameters configured.
This allows users to enable or disable the System Log State. The default is Disabled.
Syslog State
Click Apply to implement changes made.
DGS-3024 Gigabit Ethernet Switch Manual
25