Enable Method Lists - D-Link DGS-3024 - Switch Manual

Enable Method Lists

The Enable Method Lists window is used to set up Method Lists to promote users with user level privileges to Administrator
(Admin) level privileges using authentication methods on the Switch. Once a user acquires normal user level privileges on the
Switch, he or she must be authenticated by a method on the Switch to gain administrator privileges on the Switch, which is
defined by the Administrator. A maximum of eight (8) Enable Method Lists can be implemented on the Switch, one of which is a
default Enable Method List. This default Enable Method List cannot be deleted but can be configured.
The sequence of methods implemented in this command will affect the authentication result. For example, if a user enters a
sequence of methods like TACACS - XTACACS - Local Enable, the Switch will send an authentication request to the first
TACACS host in the server group. If no verification is found, the Switch will send an authentication request to the second
TACACS host in the server group and so on, until the list is exhausted. At that point, the Switch will restart the same sequence
with the following protocol listed, XTACACS. If no authentication takes place using the XTACACS list, the Local Enable
password set in the Switch is used to authenticate the user.
Successful authentication using any of these methods will give the user an "Admin" privilege.
To view the following table, click Security > Access Authentication Control > Enable Method Lists:
To delete an Enable Method List defined by the user, click the
be deleted. To modify an Enable Method List, click on its hyperlinked Method List Name. To configure a Method List, click the
Add button.
Both actions will result in the same window to configure:
DGS-3024 Gigabit Ethernet Switch Manual
NOTE: To set the Local Enable Password, see the next section, entitled
Local Enable Password.
Figure 8- 18. Enable Method List Settings window
Figure 8- 19. Enable Method List - Edit window
under the Delete heading corresponding to the entry desired to
103