Connecting Devices To The Switch - D-Link DGS-3024 - Switch Manual

In the above example, the Switch was assigned an IP address of 10.53.13.224 with a subnet mask of 255.0.0.0. The system
message Success indicates that the command was executed successfully. Please remember to save your new settings before you
logout or they will be lost.
The Switch can now be configured and managed via Telnet and the CLI or via the Web-based management.

Connecting Devices to the Switch

After you assign IP addresses to the Switch, you can connect devices to the Switch.
To connect a device to an SFP transceiver port:
•
Use your cabling requirements to select an appropriate SFP transceiver type.
•
Insert the SFP transceiver (sold separately) into the SFP transceiver slot.
•
Use the appropriate network cabling to connect a device to the connectors on the SFP transceiver.
DGS-3024 Gigabit Ethernet Switch Manual
Figure 5- 4. Assigning the Switch an IP Address
NOTICE: When the SFP transceiver acquires a link, the associated
integrated 10/100/1000BASE-T port is disabled.
17