Table of Contents
Advertisement
6.2
LSI Logic Embedded SATA RAID Setup
Utility (For PA4 model Only)
The LSI Logic Embedded SATA RAID Setup Utility allows you to create RAID 0,
RAID 1, or RAID 10 set(s) from SATA hard disk drives connected to the SATA
connectors supported by the motherboard Southbridge chip.
To enter the LSI Logic Embedded SATA RAID Setup Utility:
1.
Turn on the system after installing all the SATA hard disk drives.
2.
During POST, the LSI Logic Embedded SATA RAID Setup Utility
automatically detects the installed SATA hard disk drives and displays any
existing RAID set(s). Press <Ctrl> + <M> to enter the utility.
•
•
3.
The utility main window appears. Use the arrow keys to select an option from
the Management Menu, then press <Enter>. Refer to the Management Menu
descriptions on the next page.
At the bottom of the screen is the legend box. The keys on the legend box
allow you to navigate through the setup menu options or execute commands.
The keys on the legend box vary according to the menu level.
6-4
The LSI Logic Embedded SATA RAID auto configures to RAID 1 when the
SATA to RAID Mode is enabled.
The RAID setup screens shown in this section are for reference only and
may not exactly match the items on your screen due to the controller
version difference.
Chapter 6: RAID configuration
Advertisement
Table of Contents
