Asus TS300-E5 - 0 MB RAM User Manual page 105

Memory Remap Feature [Enabled]
Allows you to enable or disable the remapping of the overlapped PCI memory
above the total physical memory. Enable this option only when you install 64-bit
operating system. Configuration options: [Disabled] [Enabled]
DRAM Frequency [Auto]
Allows you to set the DDR operating frequency.
Configuration options: [Auto] [667 MHz] [800 MHz]
Configure DRAM Timing by SPD [Enabled]
When this item is enabled, the DRAM timing parameters are set according to the
DRAM SPD (Serial Presence Detect). When disabled, you can manually set the
DRAM timing parameters through the DRAM sub-items.
Configuration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to select the graphics controller as the primary boot device.
Configuration options: [PCI/PEG] [PEG/PCI]
PEG Port Configuration
PEG Port [Auto]
Configuration options: [Auto] [Disabled]
South Bridge Configuration
Advanced
South Bridge chipset Configuration
SMBUS Controller
SLP_S4# Min. Assertion Width
SMBUS Controller [Enabled]
Allows you to enable or disable the SMBUS Controller.
Configuration options: [Enabled] [Disabled]
SLP_S4# Min. Assertion Width [1 to 2 seconds]
Allows you to select the SLP_S4# Min. Assertion Width.
Configuration options: [4 to 5 seconds] [3 to 4 seconds] [2 to 3 seconds]
[1 to 2 seconds]
ASUS TS300-E5
BIOS SETUP UTILITY
[Enabled]
[1 to 2 seconds]
5-21