Table of Contents
Advertisement
2.5
Front panel assembly
2.5.1
Removing the front panel assembly
Before you can install a 5.25-inch drive, you should first remove the front
panel assembly (front bezel and front panel cover). The front panel assembly
is attached to the chassis through three hooked tabs on the left side and four
hinge-like tabs on the right side.
To remove the front panel assembly:
1.
Locate the two hooked tabs on the
chassis side rail.
2.
Press each lock tab to release the
front panel from the chassis.
3.
Pull and swing the left edge of the front
panel outward.
2-12
Chapter 2: Hardware setup
Advertisement
Table of Contents
