Scan - Uniden MHS235 Owner's Manual

Floating vhf marine radio
Hide thumbs Also See for MHS235:
Table of Contents

Advertisement

Normal Mode with Weather Alert Watch
If you activate Weather Alert Watch while
operating in Normal mode, the radio checks the most
recently used weather channel every seven
seconds. If it detects a weather or other hazard alert,
it will switch to that weather channel. (If you are actively
transmitting, the radio waits until you finish your transmission
before checking the weather channel.)
Normal Mode with Triple Watch or Dual Watch
If you activate Triple Watch while operating in Normal mode, the radio checks channels 16
and 9 every few seconds; with Dual Watch turned on, the radio only checks channel 16.
The radio will not check channels 16 or 9 while you are actively transmitting; it waits until
your transmission is finished and then checks the channels.

Scan

You can save any channel (except Weather channels) into memory and then use Scan
mode to monitor those channels from lowest to highest. If the radio detects a signal on a
channel, it stays on that channel as long as the signal is received; when the signal stops,
the radio continues scanning.
When it detects a signal, the radio stays
Channel Up button or the signal stops.
08
Using the Radio in Scan Mode
To activate Scan mode, press and hold CLR/SCAN. The radio scans channels in
x
memory.
You must have at least two channels in memory to start a scan.
x
You cannot transmit while in Scan mode.
x
To save a channel into memory, select the channel, then press and hold the GPS/
x
MEM button. The MEM icon displays whenever you tune to that channel.
To remove a channel from memory, set the radio to that channel, then press and hold
x
the GPS/MEM button. The MEM icon no longer displays.
When the radio stays on a channel, press Channel Up to leave that channel and
x
resume scanning.
To end the scan, press and hold the CLR/SCAN button again; the radio remains on the
x
last scanned channel. You can also press WX/SOS to change to Weather mode.
Scan Mode with Weather Alert Watch
When you activate Weather Alert Watch through the Normal menu while in Scan mode, the
radio checks the most recently-used weather channel every seven seconds, then continues
scanning the next channel in memory:
E-10
on the channel until you press the
10
11
12
13
The radio scans about
5 channels in 0.3 seconds.
Uniden MHS235 Radio Owner's Manual
Monitoring Channel 25
Resume
scan
17
15
14
Every 7 seconds,
the radio checks
wx
the last-used
weather channel.
WX Alert
Watch on

Advertisement

Table of Contents
loading

Table of Contents