Konica Minolta bizhub C220 System Administrator Manual page 40

4. Using the Universal Print Driver
Search Settings
When using "Network Search", you can set detailed search parameters in the "Search
Settings" dialog box shown below.
Figure 4-2-11 Search Settings Dialog Box
The settings and their descriptions are described below.
Table 4-2-4 Details about Devices in the History View
Parameter
IP Version
IPv4 Priority
IPv6 Priority
IPv4 Only
IPv6 Only
Subnet Settings
IP Address/Subnet
Subnet Mask
Search Method(IPv4)
Unicast
Broadcast
36
Description
Specify the IP protocol version to give priority for searching.
Give priority to IPv4. This is the default for Windows Vista/
Server 2008 or later operating systems.
Give priority to IPv6.
Only search for IPv4. "IPv4 Only" is the only choice available on
Windows 2000/XP/Server 2003 (other choices will be grayed
out).
Only search for IPv6.
Select this checkbox to set the subnet to search for. If this
checkbox is cleared, then IP address and subnet mask are
acquired for computers with UPD installed, and the search is
performed on that computer's subnet. This cannot be set if
"IPv6 Only" is selected.
Specify the IP address of the subnet to search.
Specify the subnet mask of the subnet to search.
Specify the IPv4 search method. This is grayed out if "IPv6
Only" is selected.
Perform the search via unicast. This will make the search take
longer, because the computer will communicate with devices
on the network on a 1-to-1 basis. And also it may be possible to
detect devices that were not detected using a broadcast.
Perform the search via broadcast. This reduces the search
time, because it communicates with all the devices on the
network at once.