AEG OKO-LAVAMAT 60300 Instruction Book page 29

Malfunction
Washing is not spun
properly, water is still
visible in the drum.
It is not possible to
open the door.
Rinse water is cloudy.
Remnants of detergent
are building up in the
detergent drawer.
Program selector skips
k (PRE WASH).
Program selector
remains stationary at
position 7 (SOAKING).
Stain remover is not
washed in.
Possible Cause
Drain hose is kinked.
Maximum pumping height
(drain height 1m above the
floor on which the machine
is standing) exceeded.
Circulation pump is blocked.
In the case of siphon con-
nection: siphon is blocked.
Program is not yet finished;
M (ON/OFF) indicator lamp is
illuminated.
This is probably due to using
a detergent with a high sili-
cate content.
Tap is not fully open.
The sieve in the threaded fit-
ting on the water inlet hose
at the tap is blocked.
Sieve on threaded fitting for
the water inlet hose on the
machine is blocked.
k (PRE WASH) combined
with s (WOOLLENS).
Position 7 (SOAKING) is com-
bined with s (WOOLLENS).
Position 1 (STAIN) is com-
bined with s (WOOLLENS).
Operating instructions
Remedy
Remove kink.
Please contact customer ser-
vice who have a retrofit kit
for pumping to heights of
greater than 1m.
Switch off the machine and
unplug from the mains, clean
the circulation pump.
Clean siphon.
Wait until the M (ON/OFF)
indicator lamp extinguishes.
No negative impact on the
rinsing results, possibly use
liquid detergent.
Open tap fully.
Clean sieve.
Clean sieve.
k (PRE WASH) cannot be
combined with s
(WOOLLENS).
Position 7 (SOAKING) cannot
be combined with
s (WOOLLENS).
Position 1 (STAIN) cannot be
combined with s
(WOOLLENS).
29