Do you have a question about the OKO_LAVAMAT 608 and is the answer not in the manual?
Questions and answers
Hassan
March 31, 2025
سلام یک لباس شویی مدل oko lavamat 509 n aeg دارم روی خشک کن نمی رود علت چیه
1 comments:
Mr. Anderson
March 31, 2025
The AEG ÖKO_LAVAMAT 608 washing machine may not go into the spin cycle for several reasons:
1. Unbalanced Load: If the laundry is unevenly distributed, the machine may skip the spin cycle to prevent damage. Try redistributing the load.
2. Drainage Problem: If the water is not draining properly, the spin cycle may not start. Check for a clogged pump filter, blocked drain hose, or malfunctioning drain pump.
3. Lid or Door Lock Issue: The machine will not spin if the door is not securely locked. Inspect the door lock mechanism.
4. Spin Cycle Not Selected: Ensure the correct program and spin setting are selected.
5. Motor or Drive Belt Fault: If the motor or drive belt is faulty, the drum may not spin. This requires inspection or replacement.
6. Control Board or Sensor Fault: A failure in the electronic control board or sensors can prevent the spin cycle.
7. Too Much Suds: Excessive detergent can cause too many suds, leading the machine to stop before spinning.
Check each of these systematically to identify the cause.
Need help?
Do you have a question about the OKO_LAVAMAT 608 and is the answer not in the manual?
Questions and answers
سلام یک لباس شویی مدل oko lavamat 509 n aeg دارم روی خشک کن نمی رود علت چیه
The AEG ÖKO_LAVAMAT 608 washing machine may not go into the spin cycle for several reasons:
1. Unbalanced Load: If the laundry is unevenly distributed, the machine may skip the spin cycle to prevent damage. Try redistributing the load.
2. Drainage Problem: If the water is not draining properly, the spin cycle may not start. Check for a clogged pump filter, blocked drain hose, or malfunctioning drain pump.
3. Lid or Door Lock Issue: The machine will not spin if the door is not securely locked. Inspect the door lock mechanism.
4. Spin Cycle Not Selected: Ensure the correct program and spin setting are selected.
5. Motor or Drive Belt Fault: If the motor or drive belt is faulty, the drum may not spin. This requires inspection or replacement.
6. Control Board or Sensor Fault: A failure in the electronic control board or sensors can prevent the spin cycle.
7. Too Much Suds: Excessive detergent can cause too many suds, leading the machine to stop before spinning.
Check each of these systematically to identify the cause.
This answer is automatically generated