Download  Print this page

Environment Concerns - AEG HK654200IB User Manual

Hide thumbs



Environment concerns

The Automatic Heat Up func-
tion does not operate.
The heat setting changes be-
tween two levels.
The sensor fields become hot.
There is no signal when you
touch the panel sensor fields.
comes on
comes on
and number comes on.
comes on
If you tried the above solutions and cannot repair the problem, speak to your dealer or the
customer service. Give the data from the rating plate, three digit letter code for the glass
ceramic (it is in the corner of the glass surface) and an error message that comes on.
Make sure, you operated the appliance correctly. If not the servicing by a customer service
technician or dealer will not be free of charge, also during the warranty period. The instruc-
tions about the customer service and conditions of guarantee are in the guarantee booklet.
The symbol
treated as household waste. Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the
• There is still residual heat on the cooking zone. Let the cooking
zone become sufficiently cool.
• The highest heat setting is set. The highest heat setting has the
same power as the Automatic Heat Up function.
The Power management is activated. See the section Power man-
The cookware is too large or you out it too near to the controls.
Put large cookware on the rear cooking zones if it is necessary.
The signals are deactivated. Activate the signals (see OffSound
The Automatic Switch Off operates. Deactivate the appliance and
activate it again.
• No cookware on the cooking zone. Put cookware on the cook-
ing zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for
the cooking zone. Move cookware to a smaller cooking zone.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If
There is an error in the appliance, because a cookware boils dry or
you use not correct cookware. The protection against become too
hot for the cooking zone operates. The Automatic Switch Off op-
Deactivate the appliance. Remove the hot cookware. After, ap-
proximately 30 seconds activate the cooking zone again.
should go out of the display, residual heat indicator can stay. Let
the cookware become sufficiently cool and check it with the sec-
tion Cookware for the induction cooking zone.
on the product or on its packaging indicates that this product may not be
Possible cause and remedy
comes on again, speak to the service centre.