Table of Contents
Advertisement
Extended digital zoom
●
the zoom increments to be smooth and continuous
between digital and extended digital zoom,
(paused)
allows the zoom increments to pause at
the digital and extended digital step point, and
allows a limited amount of zoom while retaining the
image resolution. Use the extended zoom only
when getting closer to the subject is more
important than the final image quality. The overall
quality of a digitally zoomed image is always lower
than that of an unzoomed image.
Capture tone
— Set the tone that sounds when you
●
capture an image.
Memory in use
●
images.
Restore camera settings
●
settings to default values.
Colour and lighting settings
In the active toolbar, select from the following:
Flash mode
( ) (image only) — Select the desired
●
flash mode.
Colour tone
( ) — Select a colour effect.
●
White balance
●
condition. This allows the camera to reproduce
colours more accurately.
Exposure compensation
●
are shooting a dark subject against a very light
66
background, such as snow, adjust the exposure to
—
On (continuous)
— Select where to store your
— Restore the camera
( ) — Select the current lighting
( ) (image only) — If you
allows
+1 or +2 to compensate for the background
brightness. For light subjects against a dark
background, use -1 or -2.
On
Sharpness
●
Off
sharpness of the image.
Contrast
( ) (image only) — Adjust the difference
●
between the lightest and darkest parts of the image.
Light sensitivity
●
light sensitivity in low light conditions to avoid too
dark images.
The screen display changes to match the settings you
make.
The available settings vary depending on the selected
camera.
The setup settings are shooting-mode specific.
Switching between the modes does not reset the
defined settings.
The setup settings return to the default settings when
you close the camera.
If you select a new scene, the colour and lighting
settings are replaced by the selected scene. You can
change the setup settings after selecting a scene if
needed.
Video settings
To change the main settings, in the video mode, select
Options
Settings
>
( ) (image only) — Adjust the
( ) (image only) — Increase the
and from the following:
Advertisement
Table of Contents
