Table of Contents
Advertisement
ACTiSYS Corp.
INTRODUCTION
This document provides instructions to install the ACT IR220L+/220L/200L Serial-IR dongle along with
Windows 98/ME/2000 device driver. It is assumed that the user is familiar with basic operation of Window
98/ME/2000.
PACKING LIST
When you unpack the package, the following items should be found.
1.
ACT-IR220Lplus or ACT-IR220L or ACT-IR200L.
2.
User's Guide
SYSTEM REQUIREMENTS
To use ACT-IR220L+/220L/220L, your computer MUST meet the following requirements.
1.
Window 98/ME/2000.
2.
One unoccupied Serial (Rs232) COM port .
3.
One unoccupied virtual comport (Com4)
BIOS SETUP Verification
Before installing the device driver, you MUST setup or verify your BIOS FIRST. Below demonstrates a
example of ACT-IR220L+ being installed on Com2.
1. Choose PNP & PCI from BIOS SETUP
PNP OS Installed: NO
Resource Controlled by: Manual
2. Choose Integrated Peripherals from BIOS SETUP
Onboard UART2 Serial Port 2 : 2F8H/IRQ3
Onboard IR function: Disable or
UART2: Normal
Release 1.5
ACTiSYS Corporation 2001
Serial-IR Dongle Installation Manual
All Rights Reserved
4
Advertisement
Table of Contents
