Table of Contents
Advertisement
INTRODUCTION
1)
This document provides instructions to install the ACT IR210L IR Dongle along with Windows
98/ME/2000/XP device driver. It is assumed that the user is familiar with the basic operation of
Window 98/ME/2000/XP.
PARTS CHECK LIST
2)
When you unpack the package, the following items should be found.
1. ACT-IR210L Adapter
2. 5 pins Motherboard Connector
3. User's Guide
4. 5 pins to 6 pins changer
SYSTEM REQUIREMENTS
3)
To use ACT-IR210L, your computer MUST meet the following requirements.
1. Window 98/ME/2000/XP.
2. Built in infrared I/O controller or super I/O chip on the motherboard with infrared connector
available and documented in the user's manual.
BIOS SETUP
4)
You MUST setup BIOS FIRST. It assumed that your IR Dongle would be installed to serial Com
port 2 before install the device driver.
1. Choose PNP & PCI from
BIOS SETUP
PNP OS Installed: NO
Resource Controlled by: Manual
2. Choose Integrated Peripherals from BIOS SETUP
Onboard UART2 Serial Port 2 : 2F8H/IRQ3
Onboard IR function: SIR, HPSIR or IrDA or 3/16 baud
RXD,TXD Active: Hi,Lo
IR Transmission delay: Disable
IR FUNCTION DUPLEX: HALF
IR Use Pins: IR-RX2,TX2
WINDOWS 98/ME/2000/XP INSTALLATION GUIDE
5)
Copyright 2003-2006 ACTiSYS Corp.
The Wireless Connectivity Expert
Page
IR210L IrDA Motherboard Adaptor
5
14
of
User's Manual
Feb. 14, 2006
Ver. 1.5.1
Advertisement
Table of Contents
