Load Sensing - Sensor Logic - AEG FAVORIT 65050 VI User Instructions

Changing the start delay:
As long as the programme has not started, you are still able to cancel
the start delay by pressing the b button.
Cancelling the start delay:
As long as the programme has not started you are still able to cancel
the start delay. Continue pressing the b button until the length of the
selected programme appears in the multi-display. The selected pro-
gramme will begin immediately after the dishwasher door has been
closed.
Changing the programme after the start delay has been set:
As long as the programme has not started, you are still able to change
the start delay set by pressing a programme button.
0 1. Press the button for the new programme and hold it down.
First, the indicator for the programme that has just been selected will
flash.
After several seconds only the indicator for the new programme will be
flashing.
2. Release the programme button.
3. Close the door.
The programme will start automatically following a countdown of the
hours set.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower basket, an intelligent electronic system
adjusts the amount of water and the duration of the wash programme
to the number of dishes. By this means it is possible to wash only a few
dishes quickly and economically. At half load (6 place settings), up to
2 litres of water and 0.2 kWh of electricity are saved.
Operating Instructions
31