Load Sensing - Sensor Logic; Switching Off The Dishwasher; Emptying The Dishwasher - AEG ÖKO FAVORIT 60750 VI User Instructions

Operating Instructions
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.

Switching Off the Dishwasher

At the end of the wash programme a continuous tone sounds for
5 seconds.
Hot steam may escape from the appliance when opening the door
1
immediately after the end of the programme. Open the door carefully.
0 1. Open the door
2. Press the ON/OFF switch. The ON/OFF switch indicator extinguishes.
If the dishwasher is not switched off, the continuous tone sounds again
after 10 minutes.

Emptying the Dishwasher

• Hot dishes are sensitive to knocks. The dishes should therefore be
3
allowed to cool down before removing them from the appliance.
• Leave the dishes in the dishwasher for approx. 15 minutes after the
end of the programme so that they dry better and can cool down.
• First empty the lower rack, and then the upper rack. By using this
procedure you will avoid any water that may be remaining in the
upper rack, dripping onto the dishes in the lower rack and leaving
water marks.
26