Installing And Removing Xenpak Modules (Catalyst 3750G-16Td Switch) - Cisco 3750G-12S - Catalyst Switch - Stackable Hardware Installation Manual

Chapter 2 Switch Installation
Unlock and remove the SFP module, as shown in
Step 3
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver
or other long, narrow instrument to open the bale-clasp latch.
Figure 2-49
1 3
X
X
1
Warning When the Catalyst 3750-12S switch and 100BASE-FX MMF small form-factor pluggable (SFP) module
(model number GLC-GE-100FX) are running, the surface temperature of the removed SFP module might
be hot. Statement 377
Step 4 Grasp the SFP module between your thumb and index finger, and carefully remove it from the
module slot.
Step 5 For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the
optical interfaces clean.
Place the removed SFP module in an antistatic bag or other protective environment.
Step 6
Installing and Removing XENPAK Modules
(Catalyst 3750G-16TD Switch)
These sections describe how to install and remove XENPAK modules:
•
•
XENPAK modules are inserted into the XENPAK module slot on the front panel of the Catalyst
3750G-16TD switch. These field-replaceable transceiver modules provide 10-Gigabit interfaces.
OL-6336-10
Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver
1 4
1 5
1 6
1 7
1 8
1 9
2 0
2 1
2 2
2 3
2 4
23 X
24 X
Bale clasp
Removing SFP Modules from SFP Module Slots, page 2-34
Removing a XENPAK Module, page 2-38

Installing and Removing XENPAK Modules (Catalyst 3750G-16TD Switch)

Figure 2-49.
C a ta ly s t
3 7 5 0
S E R IE S
1
2
1
Catalyst 3750 Switch Hardware Installation Guide
2-35