Connecting To The Console Port - Cisco 3750G-12S - Catalyst Switch - Stackable Hardware Installation Manual

Appendix D Configuring the Switch with the CLI-Based Setup Program

Connecting to the Console Port

You can use the console port to perform the initial configuration. To connect the switch console port to
a PC, use the supplied RJ-45-to-DB-9 adapter cable.
If you have stacked your switches, connect to the console port of one of the switches in the stack. The
Note
initial configuration for the entire stack can be performed on any switch in the stack.
Follow these steps to connect the PC or terminal to the switch:
Using the supplied RJ-45-to-DB-9 adapter cable, insert the RJ-45 connector into the console port on the
Step 1
rear of a switch, as shown in
Attach the DB-9 female DTE of the adapter cable to a PC serial port, or attach an appropriate adapter to
Step 2
the terminal.
Figure D-4
1 Catalyst 3750 switches
2 Power cord
OL-6336-09
Figure
Connecting a Switch to a PC
CO NS OL
E
DC INP
RAT ING SPE CIF
100 -200
1.6A -0>9
V ~
A, 50-6
0 HZ
CO NS OL
E
DC INP
RAT ING SPE CIF
100 -200
1.6A -0>9
V ~
A, 50-6
0 HZ
CO NS OL
E
DC INP
RAT ING SPE CIF
100 -200
1.6A -0>9
V ~
A, 50-6
0 HZ
3
2
3 RJ-45-to-DB-9 adapter cable
D-4.
1
UTS FOR
POW ER
REM OTE
SUP PLY
IED IN
+12 v MAN UAL
@8. 5a
UTS FOR
POW ER
REM OTE
SUP PLY
IED IN
+12 v MAN UAL
@8. 5a
UTS FOR
POW ER REM OTE
SUP PLY
IED IN
+12 v MAN UAL
@8. 5a
Catalyst 3750 Switch Hardware Installation Guide
Connecting to the Console Port
D-5