On-Screen Messages - Panasonic Viera TX-L32E5B Operating Instructions Manual

Problem
The TV does not switch on
The TV goes into Standby
mode
The remote control does
not work or is intermittent
Parts of the TV become
hot
The LCD panel moves
slightly when it is pushed
with a finger
Clattered sound might be
heard
Overcurrent error
message appears
An error message appears

On-screen messages

Message
All tuning data will be erased
Are you sure ?
Are you sure you want to
delete this timer ?
Press OK to delete timer.
Press RETURN to return.
Bad signal
Child Lock is active!
Press OK to enter PIN.
External Recording Due to
Start
Feature not available.
Feature not available.
Press OK to view how it works.
Found new software version
.
Press OK to start update (may
take over 40 mins) or press
EXIT to ignore and you can
update when TV is in standby
96
Check the mains lead is plugged into the TV and the socket outlet.
Auto power standby function is activated.
The TV enters Standby mode about 30 minutes after analogue broadcasting
ends.
Are the batteries installed correctly?
Has the TV been switched on?
The batteries may be running low. Replace them.
Point the remote control directly at the front of the TV (within about 7 m and a
30 degree angle of the front of the TV).
Situate the TV away from sunshine or other sources of bright light not to shine
on the TV's remote control signal receiver.
Even when the temperature of parts of the front, top and rear panels has risen,
these temperature rises do not cause any problems in terms of performance or
quality.
There is some flexibility around the panel to prevent damage to the panel.
The panel might move slightly when it is pushed with a finger, and clattered
sound might be heard. This is not a malfunction.
The connected USB device might cause this error. Remove the device and turn
the TV off with Mains power On / Off switch, then turn it on again.
Check foreign objects are not inside the USB port.
Follow the message's instructions.
If the problem persists, contact your local Panasonic dealer or the authorised
service centre.
[Shipping Condition] will erase all tuning data.
Confirm correct operation.
Confirm correct operation.
The signal is weak. Check the aerial is plugged in properly. It may be
necessary to have an aerial installer check the signal and aerial alignment.
Reset channels. (p. 44)
The selected channel is locked in Child Lock (p. 50). You must enter the PIN
number before the channel will be displayed.
This message will appear 2 minutes before timer programming event for
external recording due to start.
It is not possible to record from AV2 (COMPONENT) or HDMI. Connect the
recorder to the TV using a fully wired SCART cable for recording from the TV
tuner.
Confirm Q-Link or VIERA Link settings.
The selected feature on VIERA TOOLS is not available. Press the OK button to
view the demonstration to explain how to use it.
There is a new software available.
Causes / Actions
(p. 10)
(p. 7)
Meaning / Action
(p. 51)
(p. 74 - 77)