Table of Contents
Advertisement
Problem
Cannot connect to the
network
Cannot select the
file during DLNA
operations
Cannot operate
VIERA Connect
The TV does not switch
On
The TV goes into
Standby mode
The remote control
does not work or is
intermittent
Parts of the TV become
hot
The LCD panel moves
slightly when it is
pushed with a finger
Clattered sound might
be heard
Overcurrent error
message appears
An error message
appears
On screen messages
Message
All contents will be lost.
Are you sure to delete this device?
All tuning data will be erased
Are you sure ?
Are you sure you want to delete
this timer ?
Press OK to delete timer.
Press RETURN to return.
Bad signal
Child Lock is active!
Press OK to enter PIN.
•
Check the LAN cable is connected properly.
•
Check the connections and settings.
•
Check the network equipment and network environment.
•
The router may not be set to issue IP address automatically. If the network administrator
prefers to allocate an IP address, set an IP address manually.
•
The router may be using MAC address filtering (security setting).
Confirm the MAC Address of this TV (p. 91) and set the router to be able to use it.
•
If the problem persists, consult your Internet Service Provider or telecommunications
company.
•
Is media server of the connected equipment prepared?
•
Check applicable data format.
•
Check the connections and settings.
•
The server or connected line might be busy now.
•
Press and hold the standby On / Off switch on the remote control for about 1 second if
Power LED is red.
•
Check the mains lead is plugged into the socket.
•
The fuse in the mains plug may have blown. Replace it with one of an identical rating
(p. 4)
•
Auto power standby function is activated.
•
The TV enters Standby mode about 30 minutes after analogue broadcast ends.
•
Are the batteries installed correctly?
•
Has the TV been switched On?
•
The batteries may be running low. Replace them.
•
Point the remote control directly at the front of the TV (within about 7 m and a 30
degree angle of the front of the TV).
•
Situate the TV so that sunshine or other sources of bright light do not shine on the TV's
remote control signal receiver.
•
Temperature rises of parts of the front, top and rear panels will not pose any problems in
terms of performance or quality of the TV.
•
There is some flexibility around the panel to prevent damage to the panel.
•
The panel might move slightly when it is pushed with a finger, and clattered sound
might be heard. This is not a malfunction.
•
The connected USB device might cause this error. Remove the device and turn the TV
Off with Mains power On / Off switch, then turn it On again.
•
Check if foreign objects are inside the USB port.
•
Follow the message's instructions.
•
If the problem persists, contact your local Panasonic dealer or the authorized Service Centre.
•
Once you format the USB HDD, all the recorded programme will be erased.
•
[Shipping Condition] will erase all tuning data
•
Confirm correct operation.
•
Confirm correct operation.
•
The signal is weak. Check the aerial is plugged in properly. It may be necessary to
have an aerial / dish installer check the signal and aerial / dish alignment.
•
Reset channels.
(p. 48, 49)
•
The selected channel is locked in Child Lock (p. 60). You must enter the PIN number
before the channel will be displayed.
Actions
(p. 86)
(p. 86 - 91)
(p. 85)
(p. 108, 109)
(p. 86 - 91)
(p. 9)
(p. 8)
Meaning / Action
(p. 62)
(p. 88)
117
Advertisement
Table of Contents
