Cache Memory - HP Kayak XW A2-U2-W2 Handbook

HP Kayak XU (up to 333 MHz) & HP Kayak XW Series A2, U2, W2
Installing a Dual Processor / Replacing a processor
HP Kayak XU and XW 6/xxx PC Workstations are supplied with dual processor
slots and either one or two processors installed. Single processor models can be
upgraded to dual processor systems by installing the second processor
accessory in the vacant slot.
The second processor must be a Pentium II processor of the same speed and
level-2 cache memory capacity as the first. It is installed by gently sliding the
processor into the vacant processor connector slot until the two plastic clips at
the sides engage to lock the processor into place.
Every processor that is installed, or replaced, must be accompanied by the
voltage regulator module (VRM) that was supplied with it. Each VRM is specific
4
to the processor with which it was supplied, and should only be used with that
processor.
After installation of a second processor, the operating system must be
reinstalled.
Plastic clips
Bracket pillars

Cache Memory

512 KB of level-two cache memory is integrated in the Pentium II processor
package.
4-8 HP Kayak XU (up to 333 MHz) & HP Kayak XW
Series A2, U2, W2
Heat-sink
Mini-Tower
PC Workstations