Table of Contents
Advertisement
Setting up a Scanner
You can also specify a port. If you check Enable MX lookup for this host,
you must specify a host name (not an IP address) for that server.
For outbound mail addressed to a non-local domain, there is typically no
relay host to specify. If you choose Use default MX lookup, the Scanner will
use Internet MX records to deliver the mail.
7
Click Next.
8
On the Setup Wizard Summary panel, review the settings shown.
9
If you are satisfied with the settings, click Finish to save them.
If not, click Back to revise your settings, or Cancel to end without saving any
changes.
When the configuration is complete, the Scanner will contact Symantec to
download the latest antispam filters and antivirus definitions, and the
default antivirus definition download schedule will be in place (if you have
installed an antivirus license). You can alter this schedule from the Control
Center. Refer to the Symantec Mail Security for SMTP Administration Guide
for more information.
The instructions in this section only apply if you are adding a Scanner on a
machine different from the one hosting your Control Center.
Add a Scanner
Use the Add Scanner Wizard to set up a Scanner.
Note: None of the settings you specify using the wizard are final until you click
Finish at the end of the wizard. If you step through all the panels of the wizard
and do not click Finish, you will not make any changes to configuration settings.
To configure host IP settings
1
If you are adding your first Scanner, you will now see the Add Scanner
Wizard. Skip to step 3. If you're adding a subsequent Scanner, from the
Control Center, click Settings > Hosts.
2
On the Hosts page, click Add and then click Next.
3
On the Scanner Host Settings panel, identify your new Scanner by typing a
description and a name or IP address.
4
Click Next to continue with
Installing Symantec Mail Security for SMTP
To register the Scanner
Setting up
in the next section.
35
Advertisement
Table of Contents
