Solving Media Card Reader Problems - HP Elite 7000 - Microtower PC Maintenance And Service Manual

Table C-3 Solving Hard Drive Problems (continued)
Computer will not boot from hard drive.
Cause
Boot order is not correct.
Hard drive is damaged.
Computer seems to be locked up.
Cause
Program in use has stopped responding to commands.

Solving Media Card Reader Problems

Table C-4
Media card will not work in a digital camera after formatting it in Microsoft Windows XP or Microsoft Windows Vista.
Cause
By default, Windows XP and Windows Vista will format any
media card with a capacity greater than 32MB with the FAT32
format. Most digital cameras use the FAT (FAT16 & FAT12)
format and can not operate with a FAT32 formatted card.
A write-protected or locked error occurs when attempting to write to the media card.
Cause
Media card is locked. Locking the media card is a safety feature
that prevents writing to and deleting from an SD/Memory Stick/
PRO card.
Can not write to the media card.
Cause
The media card is a read-only memory (ROM) card.
Media card is locked. Locking the media card is a safety feature
that prevents writing to and deleting from an SD/Memory Stick/
PRO card.
88 Appendix C Troubleshooting Without Diagnostics
Solving Media Card Reader Problems
Solution
Run the Computer Setup utility and change boot sequence
in Boot > Boot Device Priority.
See the Worldwide Limited Warranty for terms and conditions.
Solution
Attempt the normal Windows "Shut Down" procedure. If this
fails, press the power button for four or more seconds to turn
off the power. To restart the computer, press the power button
again.
Solution
Either format the media card in the digital camera or select FAT
file system to format the media card in a computer with
Windows XP or Windows Vista.
Solution
If using an SD card, make sure that the lock tab located on the
right of the SD card is not in the locked position. If using a
Memory Stick/PRO card, make sure that the lock tab located
on the bottom of the Memory Stick/PRO card is not in the
locked position.
Solution
Check the manufacturer's documentation included with your
card to see if it writable. Refer to the previous section for a list
of compatible cards.
If using an SD card, make sure that the lock tab located on the
right of the SD card is not in the locked position. If using a
Memory Stick/PRO card, make sure that the lock tab located
on the bottom of the Memory Stick/PRO card is not in the
locked position.