Populating Dimm Sockets - HP Elite 7000 - Microtower PC Maintenance And Service Manual

Populating DIMM Sockets

There are four DIMM sockets on the system board, with two sockets per channel. The sockets are
labeled DIMM1, DIMM2, DIMM3, and DIMM4. Sockets DIMM2 and DIMM4 operate in memory channel
A. Sockets DIMM1 and DIMM3 operate in memory channel B.
Figure 7-5
Table 7-1
Item
1
2
3
4
NOTE: A DIMM must occupy the XMM2 socket.
The system will automatically operate in single channel mode, dual channel mode, or flex mode,
depending on how the DIMMs are installed.
●
The system will operate in single channel mode if the DIMM sockets are populated in one channel
only.
●
The system will operate in a higher-performing dual channel mode if the total memory capacity of
the DIMMs in Channel A is equal to the total memory capacity of the DIMMs in Channel B. The
technology and device width can vary between the channels. For example, if Channel A is
populated with two 1-GB DIMMs and Channel B is populated with one 2-GB DIMM, the system will
operate in dual channel mode.
●
The system will operate in flex mode if the total memory capacity of the DIMMs in Channel A is not
equal to the total memory capacity of the DIMMs in Channel B. In flex mode, the channel populated
with the least amount of memory describes the total amount of memory assigned to dual channel
and the remainder is assigned to single channel. For optimal speed, the channels should be
34 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
DIMM Socket Locations
DIMM Socket Locations
Description
DIMM1 socket, Channel A
DIMM2 socket, Channel A (populate
first)
DIMM3 socket, Channel B
DIMM4 socket, Channel B (populate
second)
Socket Color
Black
Blue
Black
Blue