Download  Print this page

Threading The Machine; Winding The Bobbin - Brother LS2250PRW User Manual

Users manual - english and spanish.
Hide thumbs

Advertisement

THREADING THE MACHINE

Winding the bobbin

This section describes how to wind the thread onto the bobbin.
1 Pulling it in as
far as possible.
CAUTION
● Only use bobbins (part code: SA156, SABOBBIN, SFB: XA5539-151) that have been designed for this
sewing machine. Using other bobbins may cause damage to the machine.
● We designed the bobbin that comes with this machine. If you use bobbins from other models, the
machine will not work properly. Only use the bobbin that comes with this machine or bobbins of the
same type (part code: SA156, SABOBBIN, SFB: XA5539-151).
a
Pull up the spool pin as far as possible, and
then put a spool of thread on this pin.
b
Pass the thread around the pre-tension disk.
CAUTION
● If the spool of thread is not in the right place,
the thread may tangle on the spool pin.
c
Pass the end of the thread through the hole on
the bobbin from the inside of the bobbin.
d
Put the bobbin onto the bobbin winder shaft and
slide the bobbin winder shaft to the right. Turn
the bobbin clockwise, by hand, until the spring
on the shaft slides into the groove of the bobbin.
a Spring on the shaft
b Groove of the bobbin
a Pre-tension disk
b Bobbin winder shaft
c Bobbin
Actual size
11.5 mm
(7/16 inches)
This model
Other models
e
Turn on the sewing machine.
f
While holding the end of the thread, gently
press the foot controller to wind the thread
around the bobbin a few times. Then stop the
machine.
1
10

Advertisement

Chapters

Table of Contents

   Also See for Brother LS2250PRW

   Related Manuals for Brother LS2250PRW

This manual is also suitable for:

Sewing machineLs-2000Ls-2020Ls-30

Comments to this Manuals

Symbols: 0
Latest comments:
  • Ms Lois Sep 28, 2017 06:17:
    I can’t get my needle to move to start sewing the wheel want turn. What can I do ?