Command-Line Arguments - HP ProLiant DL320e User Manual

The following table shows what updates occur if AMS switches are currently installed.
Command
no switches
/use_ams
/use_snmp
/use_wmi
/use_ams /use_snmp
/use_ams /use_wmi
/use_wmi /use_snmp
/use_ams /use_wmi /use_snmp
NOTE: G7 and earlier servers do not support AMS.

Command-line arguments

HP SUM recognizes the following command-line arguments, which you can use to pre-populate
the GUI on the Source Selection and Review/Install Updates screens. If you specify the target and
credentials, use the /s[ilent] parameter to proceed with the installation.
You cannot use some arguments, such as /romonly and /softwareonly, together.
Help
/h[elp] or /?
Installation options
/f[orce]
/f[orce]:bundle
/f[orce]:rom
/f[orce]:software
/f[orce]:all
/g or /downgrade
/e or /rewrite
/s[ilent]
G7 and earlier servers
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Description
Displays command line help information.
Description
Overrides or downgrades an existing component
installation. This produces the same results as
/f:software.
Overrides or downgrades the existing installation of
components in the selected bundle.
Overrides or downgrades the existing installation of the
selected firmware components (applies to firmware only).
Overrides or downgrades the existing installation of the
selected software components.
Overrides or downgrades the existing installation of the
selected software components, firmware components, and
bundles.
Downgrades to an earlier version of firmware for
multi-target devices such as hard drives and array
controllers (applies to firmware only).
Downgrades to an earlier version of firmware for
multi-target devices such as hard drives and array
controllers (applies to firmware only).
Causes the installation to run silently with no GUI or console
output. All data writes to the log file. Any generated
prompts use the default option and continue the installation
without user input. If a component requires input before
installation (such as configuration information), then the
Gen8 servers
AMS
AMS
AMS and SNMP
AMS and WBEM
AMS and SNMP
AMS and WBEM
AMS, SNMP, and WBEM
AMS, SNMP, and WBEM
Command-line interface 33