Advanced Installation Of Isps In Windows; Component Configuration; Command-Line Installation; Command Line Syntax - HP Rx2620-2 - Integrity - 0 MB RAM User Manual

3 Advanced installation of ISPs in Windows

This section addresses advanced installation of ISPs in Windows.

Component configuration

Component configuration requires that Smart Components are in a write-accessible location. A
CD or read-only network share is not supported. If you have obtained your support pack from
the SmartSetup CD, copy the entire contents of the support pack directory to the local hard drive
or a network share, and then make sure the read-only attributes are cleared from all files.
Some components might have required or optional configuration settings. Configuration
parameters can include information necessary to set up the component correctly or passwords
required for software installed by the component. If the optional configuration data of a component
is not provided and the component has not been installed previously, it will use default values
for that configuration data. If the component has been previously installed and configured, then
the existing configuration information will be preserved if no changes are made to the
configuration data.
Configurable components are indicated in the Optional Actions column of the Select Items to be
Installed screen
Follow the instructions when the Item Configuration screen appears. When the configuration is
complete, the Select Items to be Installed screen reappears.

Command-line installation

The HP Smart Update Manager command line interface enables you to script custom installations.

Command line syntax

The general command line syntax for HP Smart Update Manager is:
hpsum [/h[elp]] [/?] [/f[orce]] [/r[eboot]] [/reboot_message "reboot message"]
[/reboot_delay timeout_in_seconds] [/reboot_always] [/s[ilent]] [/c[omponent]
component_to_install]... [/group "HPSUMgroup"] [/b[undle] bundlename]...
[/allow_update_to_bundle] [/allow_non_bundle_components] [/use_latest]
[/dryrun] [/continue_on_error error] [/override_existing_connection]
[/express_install] [/user username] [/passwd password] [/current_credential]
[/target "netAddress"] [/logdir "path"] [component_to_install]... [bundlename]...
The HP Smart Update Manager with HP BladeSystem c-Class Onboard Administrator or remote
hosts requires the user ID, password and the target server IP address or DNS name to log in.
NOTE:
All arguments and information enclosed in brackets are optional. The arguments may
be prefixed with either a hyphen (- ) or slash (/) character. These examples show only the /.
If no command line arguments are executed on the command line, the component GUI appears.

Command-line arguments

HP Smart Update Manager recognizes the following command line arguments. These arguments
pre-populate the GUI in the Select Items to be Installed screen. If you specify the host or group,
the Select Items to be Installed screen do not appear.
/h[elp] or /?
/f[orce]
(Figure 2-5 (page 16)). To configure a component, click Configure Now.
Displays command line Help information.
Enables you to override or downgrade an existing
installation of a given component.
Component configuration 31