Device Config; Device Configuration - Toshiba PPA60U-00L019 User Manual

■
The Wake-up on LAN function consumes power even when the
system is off. Leave the AC adaptor connected while using this
feature.
■ To enable it, you must check both the "Allow the device to wake the
computer" and "Only allow management stations to wake the
computer" check box within the "Intel Network Connection".
Power will be automatically turned on when a signal is received from an
administrator's computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in chapter 6,
battery
Enabled
Disabled
Built-in LAN
This feature enables or disables the Built-in LAN.
Enabled
Disabled

Device Config

Device Configuration

This option allows you to set how the computer's hardware devices will be
configured.
All Devices
Setup by OS
USB
USB KB/Mouse Legacy Emulation
You can use this option to enable or disable USB keyboard/mouse legacy
emulation so that, even if your operating system does not support USB
devices, you can still use a standard USB mouse and keyboard - to achieve
this you should set the appropriate option(s) to Enabled.
Enabled
Disabled
User's Manual
life.
Enables Wake-up on LAN (Default).
Disables Wake-up on LAN.
Enables Built-in LAN functions (Default).
Disables Built-in LAN functions.
The computer's BIOS will setup and configure all
devices.
The operating system will setup and configure all
of the devices that it can control (default).
Enables the USB Legacy Emulation function
(Default).
Disables the USB Legacy Emulation function.
HW Setup
Extending
7-6