Toshiba PPA60U-00L019 User Manual page 91

Observe the following to improve the fingerprint recognition success rate.
■
Enroll two or more fingers.
■
Enroll additional fingers if a recognition failure often occurs when using
already enrolled fingers.
■
Check the condition of your finger - any conditions which have changed
since enrollment, such as injury, rough skin, and extremely dry, wet,
soiled, dirty, oily, soaked or swollen fingers, may lower the recognition
success rate. Also if the fingerprint is worn down or the finger becomes
thinner or fatter, the recognition success rate may be lowered.
■
As the fingerprint for each finger is different and unique you should
ensure that only the registered or enrolled fingerprint or fingerprints are
used for identification.
■
Check the position and speed at which you swipe your finger across the
sensor - please refer to the preceding drawing.
■
The fingerprint sensor compares and analyzes the unique
characteristics in a fingerprint. However, there may be instances where
certain users are unable to register their fingerprints due to insufficient
unique characteristics in their fingerprints.
■
The recognition success rate may differ from user to user.
Setup fingerprint registration
Please use the following procedure when first using fingerprint
authentication.
■
The fingerprint authentication uses the same Windows logon ID and
password. If the Windows logon password has not been setup, please
do so before registration.
■
This sensor has memory space for at least 20 fingerprint patterns. You
might be able to register more fingerprint patterns depending on the
sensor memory usage.
1. Click Start
Fingerprint Utility, or click the utility icon in the Task Bar.
You are also able to start the Fingerprint Enrollment Wizard by using the
following methods.
■
Click the Fingerprint Application icon in the Taskbar.
2. The Enroll screen is displayed. Enter the current account password
into the Windows Password field. If no Windows password has been
configured, you will be asked to configure the new logon password.
Then click Next.
3. click the non-enrolled finger icon above the finger you want to register
and then click Next.
4. The note for enrollment operation screen is displayed. Confirm the
message and then click Next.
User's Manual
All Programs TOSHIBA
Operating Basics
Utilities TOSHIBA
4-4