Table of Contents
Advertisement
[Bottom]
Correct the bottom side on a projected image to level as shown the drawing.
Screen (solid line)
Projected area (dotted line)
NOTE:
• In the [Pincushion] screen, when the [Top] adjustment value is "0", adjustment of [Bottom] will not be possible* .
Also note that when the adjustment value of the [Top] is a small value (on the order of +5), there will be almost no change of
the image even when the [Bottom] is adjusted*.
• In [Pincushion] screen, when the [Bottom] adjustment value is less than "0", a small portion can be lost at the bottom area of
the image. To display the lost portion, use the [Digital Zoom] function to reduce the size of the projected image.*
• When [Cornerstone] or [Keystone] has already been adjusted, selection of [Pincushion] will not be possible. To display [Pin-
cushion], return the adjustment values of [Cornerstone] or [Keystone] to the factory shipping conditions.
* Each note for [Top] and [Bottom] is reversed when the [Ceiling Rear] or [Ceiling Front] is selected in [Orientation]
3
Idle and Standby mode
Information on the Idle and Standby mode is revised as follows:
(1)
The correct factory default is "Idle" mode, not Standby. (page 6-17 of the user's manual)
(2)
The current explanation states that Factory Default option resets Idle to Standby, but actually using the Factory Default will
not return the Idle mode (factory preset) to Standby. (page 6-25 of the user's manual)
Advertisement
Table of Contents
