Table of Contents
Advertisement
Battery Installation
1. Press the catch and remove the battery cover.
2. Remove both old batteries and install new ones (AA). Ensure
that you have the batteries' polarity (+/-) aligned correctly.
3. Slip the cover back over the batteries until it snaps into place.
Do not mix different types of batteries or new and old batter-
ies.
Note on Battery Installation:
If you press and hold the SELECT
ing new batteries, the remote control may fail to work properly.
Should this happen, remove the batteries and then install them
again without touching the SELECT button.
Remote Control Precautions
• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time,
• Do not place the batteries upside down.
• Do not use new and old batteries together, or use different
Operating Range for Wireless Remote Control
• The infrared signal operates by line-of-sight up to a distance
• The projector will not respond if there are objects between
button while install-
Using the Remote Control in Wired Operation
Connect one end of the supplied remote cable to the REMOTE
mini jack and the other end to the remote jack on the remote
control.
1-8
remove the batteries.
types of batteries together
7m/22 feet
Remote control
Remote sensor on the projector cabinet
of about 22 feet/7 m and within a 60-degree angle of the re-
mote sensor on the projector cabinet.
the remote control and the sensor, or if strong light falls on the
sensor. Weak batteries will also prevent the remote control
from properly operating the projector.
REMOTE
IN
REMOTE
PCCONTROL
PC CARD
USB
AUDIO IN
AUDIO OUT
IN
DVI-I
RGB
S-VIDEO IN
DVI-I IN
RGB IN
RGB OUT
AUDIO IN
VIDEO IN
R
L
/MONO
NOTE: When the remote cable is inserted into the REMOTE IN jack,
the projector's status is changed from the Standby mode to the Idle
mode.
1. Introduction
7m/22 feet
30°
30°
30°
30°
Advertisement
Table of Contents
