Optimizing Rgb Picture Automatically; Turning Up Or Down Volume; Using The Laser Pointer - NEC WT600 - XGA DLP Projector User Manual

3-4. Optimizing RGB Picture Auto-
matically
Adjusting the Image Using Auto Adjust
Optimizing RGB image automatically
Press the Auto Adjust button to optimize an RGB image auto-
matically.
[Poor picture]
OFF ON
POWER
VIDEO RGB VIEWER
AUTO ADJ. LASER
SELECT
[Normal picture]
Press the Auto Adjust button to fine-tune the computer image or
to remove any vertical banding that might appear and to reduce
video noise, dot interference or cross talk (this is evident when
part of your image appears to be shimmering). This function
adjusts the clock frequencies that eliminate the horizontal band-
ing in the image. This function also adjusts the clock phase to
reduce video noise, dot interference or cross talk. (This is evi-
dent when part of your image appears to be shimmering.)
This adjustment may be necessary when you connect your com-
puter for the first time.
NOTE:
• Some signals may not be displayed correctly or take time.
• The Auto Adjust function does not work for component and video
signal.
• If the Auto Adjust operation cannot optimize the RGB signal, try to
adjust Clock and Phase manually. See page 6-8.
3. Projecting an Image (Basic Operation)

3-5. Turning Up or Down Volume

Sound level from the speaker and the AUDIO OUT jack (RCA)
on the projector can be adjusted.
increase volume
ASPECT FREEZE 3D REFORM
HELP POINTER PIC-MUTE
VOLUME MAGNIFY SLIDE
ZOOM FOCUS FOLDER
SLIDE
LIST
Volume bar

3-6. Using the Laser Pointer

You can use the laser to draw your audience's attention to a red
dot that you can place on any object.
Press and hold the LASER button to activate the laser pointer.
CAUTION:
• Do not look into the laser pointer while it is on.
• Do not point the laser beam at a person.
3-4
decrease volume
ASPECT FREEZE 3D REFORM
HELP POINTER PIC-MUTE
VOLUME MAGNIFY SLIDE
ZOOM FOCUS FOLDER
SLIDE
LIST