Table of Contents
Advertisement
Connecting an External Monitor
You can connect a separate, external monitor to your projector
to simultaneously view on a monitor the RGB analog image you're
projecting. To do so:
1. Turn off the power to your projector, monitor and computer.
2. Use a 15-pin cable to connect your monitor to the RGB OUT
(Mini D-Sub 15 pin) connector on your projector.
3. Turn on the projector, monitor and the computer.
REMOTE
PCCONTROL
PC CARD
IN
S-VIDEO IN
DVI-I IN
AUDIO IN
VIDEO IN
R
L
/MONO
RGB signal cable
(supplied)
2-5
2. Installation and Connections
RGB OUT
USB
AUDIO IN
AUDIO OUT
DVI-I
RGB
RGB IN
RGB OUT
RGB signal cable (commercially available
or supplied with an external monitor)
To mini D-Sub 15-pin connector on the
projector. It is recommended that you use
a commercially available distribution
amplifier if connecting a signal cable
longer than the supplied one.
NOTE:
• The RGB OUT connector can output RGB signal even during idle
mode (See page 6-17 for enabling the Idle mode). When the pro-
jector goes into idle mode, the image on an external monitor dis-
appears for a moment. Note that the RGB OUT connector will not
output RGB signal during Standby mode.
• When the projector is in the Idle mode, the image may not be
correctly displayed while the cooling fans are running immedi-
ately after turning on or off the power. Note that the RGB OUT
connector will not output RGB signal during Standby mode.
• Daisy chain connection is not possible.
Advertisement
Table of Contents
