Table of Contents
Advertisement
3-2. Selecting a Source
Selecting the computer or video source
Using the Remote Control
OFF
ON
POWER
VIDEO
RGB
VIEWER
Press any one of the RGB, VIDEO
AUTO ADJ.
LASER
or VIEWER buttons.
SELECT
PJ
NOTE: If no input signal is available, the projector will display a blue
background (factory preset).
Selecting from Source List
PC CARD
FOCUS
SOURCE
MENU
Press and quickly release the SOURCE button on the projector
cabinet to display the Source list. Each time the SOURCE but-
ton is pressed, the input source will change as follows: "RGB"
(computer or DVD with component output),"DVI (DIGITAL)", "DVI
(ANALOG)", "Video" (VCR, document camera, or laser disc
player), S-Video", "Viewer" (slides on a PC card), or "LAN" (wired
or wireless signal aired from a PC).
To display the selected source, press the ENTER button.
Detecting the Signal Automatically
PC CARD
FOCUS
SOURCE
MENU
Press and hold the SOURCE button for a minimum of 1 second,
the projector will search for the next available input source. Each
time you press and hold the SOURCE button, the input source
will change as follows:
RGB → DVI (DIGITAL) → DVI (ANALOG) → Video → S-Video → Viewer
→ ...
If no input signal is present, the input will be skipped. When the
input source you wish to project is displayed, release the button.
Press the ENTER button.
Source List
3. Projecting an Image (Basic Operation)
3-3. Adjusting the Picture Size and
Position
1. Place the projector on a flat level surface and ensure that
the projector is square to the screen.
2. Make the image square
Move the projector left or right to center the image horizon-
tally on the screen.
3. Adjust the projected image size
Use the throw chart on page 2-2 to adjust the image size.
4. Finely adjust the height to keep the projector level
To finely adjust the height, use the feet on the front or rear.
Each of the feet height can be changed up to 1.2" (30 mm).
3-2
up
down
Advertisement
Table of Contents
