HP D7171A - NetServer - LPr Installation Manual page 5

2-Post Rack Installation
NOTE )
Refer to the white paper, HP Netserver High Density
Rack Solutions Overview (LP 1000r and LP 2000r) on
HP's Web site for high-density rack information.
NOTE ) The installed inner-rails shipped with the HP Netserver
are used for the 4-post HP racks. These rails must be
removed for 2-post rack installation and replaced with
the mounting brackets.
WARNING) To prevent personal injury or damage to the equipment,
use two people to mount the HP Netserver into the rack.
The HP Netserver weighs 32 lbs (14.5 kg) fully loaded.
Optional (2)
Flush Mount Brackets Only
Center Mount Brackets Only
2-Post Rack Installation (Continued)
4-Post Rack Installation
NOTE) ) Refer to the white paper, HP Netserver High Density
Rack Solutions Overview (LP 1000r and LP 2000r) on
HP's Web site for high-density rack information.
WARNING) To prevent rack instability while mounting the
HP Netserver ensure the rack's anti-tip foot is pulled
forward out of the bottom. Failure to do so could result in
injury and equipment damage.
To prevent the rack from rolling while you mount the
HP Netserver, ensure the leveler screws on the rack's
lower four corners are in firm contact with the floor.
3/4 Counter Clockwise
Flush Mounting
Center Mounting
Release
Spring
Assembly
1/4 Clockwise