Global Configuration - Behringer FCB1010 User Manual

7
MIDI FOOT CONTROLLER FCB1010 User Manual
Step 2
Fig. 2.2: PRESET selection with DIRECT SELECT enabled
As this example shows, the DIRECT SELECT feature gives you a faster access to
BANKS and PRESETS than without this function. Which option to use is entirely up
to you. As long as you need the PRESETS from one BANK only, it will be advisable
to disable the DIRECT SELECT function because this way you can recall a new
preset with only one keystroke.

2.2 GLOBAL CONFIGURATION

In the GLOBAL CONFIGURATION menu you can set the parameters that apply to
both the PRESETS and FUNCTIONS of your FCB1010 (e.g. MIDI channel selection,
SysEx SEND & RCV, DIRECT SELECT etc.). Keep the DOWN switch pressed during
power-up for about 2.5 sec to enter GLOBAL CONFIGURATION mode.
The DIRECT SELECT LED in the display lights up.
You can use the UP and DOWN keys to navigate through GLOBAL CONFIGURATION
main pages. Pressing UP leafs through the pages forward, pressing DOWN leafs
the pages backward. A corresponding LED indicates what page you are on.
CONFIG.
SELECT
MIDI FUNCTION
DIRECT SELECT
GLOBAL
CONFIGURATION
Fig. 2.3: GLOBAL CONFIGURATION menu structure
Step 1
SELECT
MIDI CHANNEL
UP
DOWN
DOWN
UP
DOWN
To leave GLOBAL CONFIGURATION menu, you need to press the DOWN/ESCAPE key
for at least 2.5 sec.
◊
Only keeping the DOWN/ESCAPE key pressed for at least
2.5 sec. saves your newly entered settings!
2.2.1 DIRECT SELECT page
Keep the DOWN/ESCAPE key pressed while you power up the unit. This takes you
to the GLOBAL CONFIGURATION menu; the green DIRECT SELECT LED lights up.
To activate DIRECT SELECT, press 10/0 key. The red LED lights up. Now, you have
to confirm activating DIRECT SELECT to be able to directly select presets. To do
this, keep DOWN/ESCAPE pressed for 2.5 sec. to exit GLOBAL CONFIGURATION.
The display now shows "00". Now you can directly select the presets, as described
in ch. 2.1.2.
2.2.2 MIDI channel setting
To get from DIRECT SELECT to MIDI FUNCTION, press UP. The MIDI FUNCTION LED
flashes correspondingly.
This is where you determine the MIDI channels that can be sent from the
FCB1010 for various MIDI functions. You can assign different MIDI channels to
MIDI functions, For example, you can control several pieces of equipment from
your FCB1010. The selection of MIDI functions is done via footswitches 1 to 10/0.
MIDI channel 1 is the factory default for all functions.
Switch MIDI function
1 PRG CHG 1
2 PRG CHG 2
3 PRG CHG 3
4 PRG CHG 4
5 PRG CHG 5
6 CNT 1
7 CNT 2
8 EXP A
9 EXP B
10/0 NOTE
Tab. 2.1: Footswitches and assigned MIDI functions
• After selecting a MIDI function by pressing one of the footswitches,
the respective footswitch LED starts to blink
• Press UP/ENTER to confirm the selected MIDI function. The MIDI CHAN.
LED lights up
• Choose the MIDI channel for the selected function, either directly via
footswitches 1 through 10/0 or by using the EXPRESSION PEDAL A.
Your selection is shown in the display
• Press UP/ENTER to confirm the chosen value and to go to the next level,
or press DOWN/ESCAPE to cancel