Restoring Factory Presets; Receiving Sysex Dumps - Behringer FCB1010 User Manual

12
MIDI FOOT CONTROLLER FCB1010 User Manual
MIDI FOOT CONTROLLER FCB1010
Fig. 2.5: Sending a SysEx-Dump

2.7.2 Receiving SysEx dumps

To send back FCB1010 data stored on a sequencer/computer before, please follow
the instructions below:
• Connect the MIDI OUT connector of your sequencer or computer to the
MIDI IN connector of the FCB1010 (see fig. 2.6)
• Keep the DOWN switch pressed during power-up to enter the
GLOBAL CONFIGURATION menu
• Press UP until the CONFIGURATION LED lights up. Now the unit is in
CONFIGURATION mode
•
Press footswitch #7 (SYSEX RCV) to "tell" the FCB1010 to wait for system-
exclusive data (the footswitch LED lights up). Start the PLAYBACK function
on your sequencer/computer to play back the previously stored file. The foot-
switch LED flashes while the FCB1010 is receiving data. Once the data have
been received correctly, the LED dies out. Now your programs are back in the
FCB1010's memory. Quit GLOBAL CONFIGURATION mode by means of a long
press on DOWN
Midi In
Midi Out
MIDI FOOT CONTROLLER FCB1010
Fig. 2.6: Receiving a SysEx dump

2.8 Restoring factory presets

This function allows you to restore factory defaults of your FCB1010.
◊
In doing so, all preset settings made by you are overwritten!
Resetting your FCB1010 lets you restore various default settings that are
optimized for use with BEHRINGER audio equipment. This is why there are three
different key combinations that let you reload the desired defaults into the
memory of your FCB1010. This key combinations are shown in table 2.5:
Switch Default setting for
1 + 6 V-AMP family products
1 + 7 BEHRINGER guitar amps
1 + 8 BASS V-AMP product range
Tab. 2.5: Reset key combinations
Keep the respective footswitches pressed for roughly 2.5 sec while powering
up your FCB1010. The displays reads "09" to "00" and the points are blinking.
When the points are no longer shown, your FCB1010 has been reset to factory
defaults and is ready for operation.
Midi Out
Midi In