Connecting Ac Power - HP StorageWorks 2/32 - SAN Switch Installation Manual

Installing the SAN Switch 2/32

Connecting AC Power

Follow these steps to power on the SAN Switch 2/32.
1. Connect the SAN Switch 2/32 power cords to the power connectors on the
Figure 13: Connecting the power cords
2. Attach the remaining ends of the power cords to power outlets.
3. Turn on the power switch (the 1 position indicates power on, the O position
38
Caution: Do not plug the power cords into the power source until the switch is
completely installed in the rack.
switch as shown in Figure
indicates power off). The switch automatically runs POST.
WARNING: Do not connect the switch to the network until the IP address is
correctly set. For instructions on setting the IP address, see
Switch 2/32 Network
13.
Addressing" on page 39.
SAN Switch 2/32 Version 4.2.x Installation Guide
SHR-2571A
"Configuring SAN