Cf_Autosetuppcadj Command; Cf_Autosetupkeystone Command; Cf_Autosetup Command; Cf_Backgnd Command - Sanyo PLC-XW300 - 3000 Lumens Manual

PLC-XW200/250/300 Expand Serial Command Functional Specifications

8.10.4 CF_AUTOSETUPPCADJ Command

Command "CF_AUTOSETUPPCADJ_%1"[CR]
"ON" ------------------- Set Auto PC ADJ. function to ON
%1
"OFF" ------------------ Set Auto PC ADJ. function to OFF
Set/Cancel Auto PC adj. function
This command is available in normal Power ON status.
Details Note) It is unable to set Keystone, PC ADJ. and Input search to OFF at once.
e.g. If projector receives Auto PC ADJ. OFF command while Keystone and Input
search are OFF, it returns error code "101".
Acceptable
Response
Unacceptable

8.10.5 CF_AUTOSETUPKEYSTONE Command

Command "CF_AUTOSETUPKEYSTONE_%1"[CR]
"AUTO" ------------------- Set Auto Keystone function to Auto
%1 "MANUAL" --------------- Set Auto Keystone function to Manual
"OFF" --------------------- Set Auto Keystone function to OFF
Set Keystone function of Auto setup
This command is available in normal Power ON status.
Details Note) It is unable to set Keystone, PC ADJ. and Input search to OFF at once.
e.g. If projector receives Keystone OFF command while Auto PC ADJ. and Input
search are OFF, it returns error code "101"..
Acceptable
Response
Unacceptable

8.10.6 CF_AUTOSETUP Command

Command "CF_AUTOSETUP_%1"[CR]
%1 "START" ------------------- Execute Auto Setup
Excute Auto Setup
Details Note) CF commands does not execute while Auto setup is in process. If the
command is sent during this, projector returns error code "302"
Acceptable
Response
Unacceptable
8.10.7

CF_BACKGND Command

Command "CF_BACKGND_%1" [CR]
"BLUE" -------------------- Select Blue Back
"USER" ------------------- Select User
%1 "BLACK" ------------------ Select Black Back
"UP" ---------- Switch forward (Blue Back→User→Black Back→Blue Back)
"DN" --------- Switch backward (Blue Back→Black Back→User→Blue Back)
Set Screen status for no signal.(Available only in the normal Power ON status)
The status set by this command is stored in EEPROM and the setting remains
Details even after the power is turned to ALL OFF status.
*When ÿ
Capture non-practice.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
1="USER" is received, error code "101" is returned, in the case of
"000" [CR]
"Error Code" [CR]
31 / 64