Cf_V - Pos Command; Cf_Ddots Command; Cf_Dline Command - Sanyo PLC-XW300 - 3000 Lumens Manual

PLC-XW200/250/300 Expand Serial Command Functional Specifications
Acceptable
Response
Unacceptable
8.5.5 CF_V – POS Command
Command "CF_V-POS_%1"[CR]
"0000~nnnn" --- Directly select Vertical Position setting value
"nnnn" shows maximum value, it is current Total Line value - Display Line value
%1
"UP" -------------- Current Vertical Position setting value + 1
"DN" -------------- Current Vertical Position setting value – 1
Set Vertical Position value of PC signal
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.6

CF_DDOTS Command

Command "CF_DDOTS_%1"[CR]
"0256"~"nnnn" --- Directly select Display Dots setting value
%1
"UP" -------------- Current Display Dots setting value + 2
"DN" -------------- Current Display Dots setting value – 2
Set Display Dots value of PC signal
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.7

CF_DLINE Command

Command "CF_DLINE_%1"[CR]
"0100"~"nnnn" --- Directly select Display Line setting value
%1
"UP" -------------- Current Display Line setting value + 1
"DN" -------------- Current Display Line setting value – 1
Set Display Line value of PC signal
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"101"[CR] ---- when Input for Video is selected
"000"[CR]
"101"[CR] ---- When Input source is Video system
"nnnn" shows maximum value, it is current Total Dots value - Horizontal
Position value
Even number is available and when odd number is set, it is rounded out.
"000"[CR]
"101"[CR] ---- When Input for Video is selected
"nnnn" shows maximum value, it is current Total Line value – Vertical
Position value
"000"[CR]
"101"[CR] ---- When Input for Video is selected
20 / 64